![]() The info LED will blink during the update.Ĩ. Transferring and updating the firmware will start. Click « Update » and enter the TeraStation’s admin password.ħ. Select the TeraStation to update if multiple TeraStation are connected.ĥ. When a TeraStation is detected, an update window will open.Ĥ. Extract the downloaded file and run « TSUpdater.exe ». Also, stop or exit any firewall software.ģ. Then they will be on the same subnet and the updater will work properly.Ģ. In this case, reconfigure the TeraStation’s IP address and subnet mask to Then the updater will _not_ work properly. The last number of the IP addresses should be different.įor example, if the IP address and subnet mask of the computer areĪnd the IP address and subnet mask of the TeraStation are The subnet masks should be the same and the first three numbers of the IP addresses should be the same. ![]() Connect the TeraStation properly and configure the TeraStation and a computer to run the updater on the same network subnet. To mount them, unplug and then reconnect them. – USB drives are not mounted automatically after a firmware update. You will receive a message when the update is finished. – Do not turn the unit off until the update is finished. – Please consult your local technical support representative if you experience any problems caused by this firmware update. ![]() – Settings: Fixed a bug where the « Confirm Operation » window appeared corrupted on certain browsers. – Settings: Fixed a bug where the username was displayed on the « Email Address » box when verifying the user account information. – Antivirus: Fixed a bug where antivirus became disabled when waking up from sleep mode. – UPS: Fixed a bug where the TeraStation may have stopped working if a UPS device was connected. ![]() – UPS: Fixed a bug where the E10 error message kept displaying if a specific UPS device was connected by a serial cable. – Failover: Fixed a bug where newly-created folders or files saved on the main TeraStation could not be copied to the backup TeraStation and the backup unit did not replace the main unit properly. – System: Fixed a bug where the TeraStation was disconnected from the network if a shared folder on this TeraStation was configured as a destination for saving recording data for the surveillance camera. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |